14.11.2013 smc7 8 0 1 of 2 smc7 8 0 technical data visible led, smd algaas smc7 8 0 is a algaas led mounted on a ceramic smd package and sealed with silicone or epoxy resin for damp proof. on forward bias, it emits a radiation of typical 10 mw at a peak wavelength of 7 8 0 nm. spe cifications (unit: mm) ? structure: algaas ? peak wavelength: typ. 7 8 0 nm ? optical output power: typ. 10 mw ? package: ceramic smd, silicon e / epoxy resin absolute maximum ratings (t a =25c) item symbol value unit power dissipation p d 190 mw forward current i f 100 ma pulse forward current** i fp 500 ma reverse voltage v r 5 v operating temperature t opr - 3 0 ? +80 c storage temperature t stg - 4 0 ? +80 c soldering temperature * t sol 240 c * must be completed within 5 seconds ** max duty cycle 1%, max puls width 10s electro - optical characteristics item symbol condition min. typ. max. unit forward voltage v f i f = 50 ma - 1.75 1.95 v reverse current i r v r = 5 v - - 10 a total radiated power* p o i f = 50 ma 5.0 10.0 - mw radiation intensity i e i f = 50 ma 2.0 5.0 - mw/sr peak wavelength p i f = 50 ma 7 65 7 80 7 9 5 nm half width ? i f = 50 ma - 3 5 - nm viewing half angle 1/2 i f = 50 ma - 55 - deg. rise time t r i f = 50 ma 80 ns fall time t f i f = 50 ma 80 ns * total radiated power is measured by photodyne #500 notes ? do not view directly into the emitting area of the led during operation! ? the above specifications are for reference purpose only and subjected to change without prior notice.
14.11.2013 smc7 8 0 2 of 2 ? do not apply any stress to the lead particularly when heat. ? after soldering the leds should be protected from mechanical shock or vibration until the leds return to room temperature. ? when it is necessary to clamp the leds to prevent soldering failur e, it is important to minimize the mechanical stress on the leds. temperature profile pcb footprint layout (unit: mm) static electricity ? leds are very sensitive to static electricity and surge voltage. it is recommended to always wear a wr ist band or an anti - electrostatic glove when handling the leds. ? all devices, equipment and machinery must be grounded properly. it is recommended that precautions should be taken against surge voltage to the equipment that mounts the leds. soldering condi tions
|
